Blu tape and stanley knifes required to cut out strips.
Perspex was cut into the correct measurements and Blu tape was cut out and stuck on.
Pliers required to cut out strip of metal.
Strip of metal to be inserted between the the two perspex sheets (this provides the model with weight).
All are glued together using super glue.
All screen parts are glued together.
Bright yellow tabs were used in between a layer of perspex and the metal sheet so that colour appears on the 'Drunk Graph'.
Fill-A-Gap was used to even out the surfaces.
Model with Fill-A-Gap on.
Spray paint was used over the entire model.
Each Blu tape strip was peeled back to reveal the yellow underneath.
Wristband was attached with super glue.
Buttons also attached using super glue.
Detail view of buttons.
In use model shot.
No comments:
Post a Comment